DIY magnetic charger for Kingwear, Lemfo, Domino smart watches and how to avoid buying the wrong cable - Gadget Victims

Post Top Ad

DIY magnetic charger for Kingwear, Lemfo, Domino smart watches and how to avoid buying the wrong cable

Within hours of receiving my first Android smart watch, I managed to loose its charger cable.
To add to the back luck, the replacement I ordered turned out to have a different pin out.
The information below should help to both avoid making the same mistake and otherwise turn the mistake into a compatible charger.


Let's start with the standard pin out of a type A male USB connector (colors are only indicative and based on the cable I used, for conventional color coding, refer to https://en.wikipedia.org/wiki/USB#Pinouts)


My mistake was to assume that any device using the same "4-pin USB magnetic charging cable" would use the same pin out.

The cable I received was in fact for the Pebble Time watch, which uses a different layout (D-,GND,5V,D+) while the MTK6580-based watches like Domino DM368, Lemfo LES1, Kingwear K88H would just observe the standard USB format seen above with power wires on the edges (GND,D+,D-,+5V).

The exact pin-out can be verified by opening (gently, don't break the flat cables!) the back cover of the watch...(something I should have done that in the first place)



I temporarily converted the Pebble cable into a MTK6580-compliant charger by doing the following: 

- Carefully cut the plastic around the magnets until you can push the  "pogo pins" out of their cavities


- Detach/cut the original wires, they are too thin to work with anyway.
- Sacrifice an old USB cable to cut and expose its 4 wires within the shielding.
- Solder the extracted pogo pins to each wire. Some "Helping Hands" clamps might be needed here.  






- First, check how the magnets snap on the watch, and then insert the pins back in to their cavities following the correct USB layout. Here I only wanted to charge the watch while I'd get a proper cable, so I didn't bother with the data pins. 






- Try the cable on a USB power source. I suggest a smart USB charger or at least use a USB tester in between to check the current. If the battery is completely flat the watch will only show signs of charging after a few minutes. The USB tester reading will tell immediately if the connection is working. 



- Finally, protect the wiring and the connector with some electric tape.



This is only a temporary solution and purchasing a (couple of) spare compatible cable(s) is by far preferable. Avoid cables with mention to Pebble or Asus ZenWatch 2.

The Domino 368 has a particularity that resides in the magnets being swapped, so, while being compatible in wiring, the spare cable I ordered from China ("for K88H") would require some DIY as well to re-locate the magnets.
The right charging cable would be specifically labelled for D368, LF16, or DM98.
The official Lemfo web site has a complete choice of cable per model (for DM368, select LF16).







1 comment:

Note: Only a member of this blog may post a comment.

Post Top Ad